20Ton Steel Plate Lifting Magnet

20Ton Steel Plate Lifting Magnet

A large enterprise specializing in the production of machinery and equipment has just install a set of 20-ton steel plate lifting magnet model # SWL-20T, produced by HVR MAG for outdoor use, which is used for lifting medium and thick plates of 12 meters in length, 2.5 meters in width, more than 10mm in thickness and 20 tons in maximum weight.

The customer used to use traditional steel plate clamps, which were simple and inexpensive to operate, but gradually failed to meet the increasing work requirements of the customer’s factory due to the following numerous shortcomings.

  • Low efficiency – requires 3-4 workers to cooperate with the handling process, difficult to operate, and requires manual separation of the clamps from the plates before and after lifting.
  • Scratch damage to the surface of the steel plate by the plate clamp.
  • Safety hazard. Occasionally, the steel plate falls off due to the clamp not being clamped properly, which is a big risk.
  • High maintenance cost. The chains and clamps are wearable consumables and need to be replaced regularly.

However, our customized steel plate electro permanent lifting magnet can solve all the above problems, and the feedback from customers is very good.

The following are the advantages of our steel plate electro permanent lifting magnet products.

  • High efficiency. The steel plate electro permanent lifting magnet can be operated independently by one person, saving labor; when hanging medium-thick plates, the magnetizing and demagnetizing time is less than 3 seconds, and the magnetization is directly applied to the plate, so it is highly efficient.
  • No damage to the surface of the steel plate
  • No security risk. No loss of magnetism due to power failure, no risk of falling of steel plate in the middle of power failure.
  • Energy saving and environmental protection. The steel plate electro permanent lifting magnet only needs electric energy in the very short time of magnetization and demagnetization, and no electricity is needed in the lifting process.
  • Zero maintenance cost. The plate lifting magnet does not need maintenance, long service life, 10 years magnetic decay <5%

If you have similar needs of steel plate electro permanent lifting magnet, please feel free to contact us and our technicians will tailor-make the right EPM product for your working conditions.

You May Also Like

About the Author: hvrmag

Leave a Reply

© 2016 HVR Magnetics Co.,Ltd., is a professional manufacturer of electro permanent magnetic system.